EdingCNC Windows driver installer

1. Run the install_drivers.cmd file
2. Complete the installation
3. If the EdingCNC controller is connected, unplug and replug the device or restart the PC.
4. Start the EdingCNC software

Troubleshooting
1. The device is still not found
	- Check Device Manager under "Ports (COM & LPT)"; when the device experiences problems related to the driver, it will display Code 52 along with a yellow warning triangle.
	  If the device still has this error, restart the computer to force the driver to reload.

2. The installer does not start
	- If the installer does not start, open a command prompt in the location of this readme file and run "install_driver.cmd".
	  Either the installer will start or a message "UNKNOWN Operating system" will appear. In case of the latter, contact us for a resolution.